The LOXONE Spot WW Tree is a recessed LED spotlight with warm white light (3 000 K). It is powered by 24 V DC and controlled directly via the LOXONE Tree interface.
Table of Contents
Mounting↑
Connect the 24 V power supply (orange/orange-white wires) and the Tree data lines (green/green-white wires).
Fold back the retaining clips and insert the spotlight into the mounting opening until it snaps into place. Make sure that no cables are pinched.
 | If the luminaire comes into contact with metal structures in the building, proper equipotential bonding must be established to protect its electronics from interference or damage. |
| The luminaire may reach high surface temperatures during operation. Install it out of reach (typically >= 2.5 m above the finished floor level). |
Commissioning↑
For commissioning, the device must be supplied with power and a connection to the Miniserver must be possible via the Tree Interface.
The light indicates whether the device is connected correctly.
Then follow the pairing procedure on the Tree Interface.
Actuators↑
| Summary | Description | Value Range |
|---|---|---|
| Smart Actuator WW | Smart actuator | ∞ |
Diagnostic Inputs↑
| Summary | Description | Unit | Value Range |
|---|---|---|---|
| Online Status Spot WW Tree | Indicates whether the device can be reached by the Miniserver. Diagnostics for Air devices Diagnostics for Tree devices Diagnostics for Extensions | Digital | 0/1 |
Properties↑
| Summary | Description | Default Value |
|---|---|---|
| Monitor online status | If checked, you will be notified via System Status or the Mailer if the device is no longer available or goes offline. | - |
| Serial number | Specifies the serial number of the device. Enter 'Auto' to automatically pair a Tree device with unknown serial number. This can only be used if there is only one Tree device of the same type on a standalone Miniserver (not in a Client-Gateway setup). Save in the Miniserver to pair the Tree device. Afterwards the program must be loaded from the Miniserver to transfer the actual serial number of the Tree device into the program. | - |
| Actuator Type | Use device with Standard Actuator(s) or Smart Actuator(s) Smart Actuators support dynamic fade times and can only be used with the Lighting Controller. | - |
| Lighting Group | Assigned Lighting Group. To create a new group simply start typing a name. | - |
Safety Instructions↑
Installation must be carried out by a qualified electrician in accordance with the applicable regulations.