The Shade Control Tree brings Silent Gliss 50 Series tubular motors into LOXONE Automatic Shading: glare-free daylight, no overheating, privacy in the evening. The robust Tree interface integrates the motor directly - plug onto the motor cable, clamp on Tree, done.
Datasheet Shade Control Tree for Silent Gliss 50 Series
Table of Contents
Mounting↑
Install the Silent Gliss 50 Series motor according to the manufacturer's instructions.
Connect the power supply (orange/white terminal) and the Tree data lines (green/white terminal).
Then attach the +24 V and GND wires of the plug connector to the 24 V motor power supply and plug the Shade Control into the Silent Gliss 50 Series motor as shown in the wiring diagram below.
Commissioning↑
For commissioning, the device must be supplied with power and a connection to the Miniserver must be possible via the Tree Interface.
Then follow the pairing procedure on the Tree Interface.
Programming↑
The LOXONE Shade Control is programmed and set up using the Automatic Shading integrated function block in LOXONE Config:
In the device properties, the duration of a complete movement can be configured. The device reports the actual travel range of the motor, allowing shades of different lengths to reach their end positions simultaneously.
The movement direction can also be inverted depending on the installation, ensuring that the up and down commands in the LOXONE App correspond to the actual movement.
The end limits can be set or adjusted directly in the LOXONE App under "Service Mode". The movement direction can also be changed here.
Actuators↑
| Summary | Unit |
|---|---|
| API Connector | Text |
Diagnostic Inputs↑
| Summary | Description | Unit | Value Range |
|---|---|---|---|
| Online Status Shade Control Tree for Silent Gliss 50 Series | Indicates whether the device can be reached by the Miniserver. Diagnostics for Air devices Diagnostics for Tree devices Diagnostics for Extensions | Digital | 0/1 |
| System temperature | Provides the internal device temperature. This is often the temperature of the CPU or another location in the device. | ° | ∞ |
| Temperature Shutdown | Input is active, when the outputs of the device have been switched off due to high device temperature. Possible reasons: Ambient temperature too high, outputs overloaded. | Digital | 0/1 |
| Motor in motion | Digital | 0/1 | |
| Motor blocked | Digital | 0/1 | |
| Obstruction detected | Digital | 0/1 | |
| Learn Mode | - | ∞ |
Properties↑
| Summary | Description | Value Range | Default Value |
|---|---|---|---|
| Monitor online status | If checked, you will be notified via System Status or the Mailer if the device is no longer available or goes offline. | - | - |
| Serial number | Specifies the serial number of the device. Enter 'Auto' to automatically pair a Tree device with unknown serial number. This can only be used if there is only one Tree device of the same type on a standalone Miniserver (not in a Client-Gateway setup). Save in the Miniserver to pair the Tree device. Afterwards the program must be loaded from the Miniserver to transfer the actual serial number of the Tree device into the program. | - | - |
| Duration of complete movement [s] | Duration of complete movement in seconds | 1...600 | 30 |
| Inverted Direction | Invert direction. Required when Up/Down connection is made the wrong way round. | - | - |
Safety Instructions↑
Installation must be carried out by a qualified electrician in accordance with the applicable regulations.
Documents↑
Datasheet Shade Control Tree for Silent Gliss 50 Series