The Curtain Control Tree brings Silent Gliss 5600 curtain systems into LOXONE Automatic Shading: open for daylight, closed against sun and for privacy — and still moved by a pull on the fabric. It sits in the drive's module slot, and the robust Tree interface integrates it directly.
Datasheet Curtain Control Tree for Silent Gliss 5600
Table of Contents
Mounting↑
Install the Silent Gliss 5600 curtain system according to the manufacturer's instructions.
Connect the Tree data lines of the Curtain Control and the power supply of the drive as shown in the wiring diagram below.
 | With AC supply, GND must additionally be connected to the drive for Tree communication. |
Then insert the Curtain Control into the module slot of the drive.
Commissioning↑
For commissioning, the device must be supplied with power and a connection to the Miniserver must be possible via the Tree Interface.
Then follow the pairing procedure on the Tree Interface.
Programming↑
The LOXONE Curtain Control is programmed and set up using the Automatic Shading integrated function block in LOXONE Config:
In the device properties, the curtain type can be configured.
The movement direction can also be inverted depending on the installation, ensuring that the up and down commands in the LOXONE App correspond to the actual movement.
The end limits can be set or adjusted directly in the LOXONE App under "Service Mode". The movement direction can also be changed here.
Actuators↑
| Summary | Unit |
|---|---|
| API Connector | Text |
Diagnostic Inputs↑
| Summary | Description | Unit | Value Range |
|---|---|---|---|
| Online Status Curtain Control Tree for Silent Gliss 5600 | Indicates whether the device can be reached by the Miniserver. Diagnostics for Air devices Diagnostics for Tree devices Diagnostics for Extensions | Digital | 0/1 |
| System temperature | Provides the internal device temperature. This is often the temperature of the CPU or another location in the device. | ° | ∞ |
| Temperature Shutdown | Input is active, when the outputs of the device have been switched off due to high device temperature. Possible reasons: Ambient temperature too high, outputs overloaded. | Digital | 0/1 |
| Motor in motion | Digital | 0/1 |
Properties↑
| Summary | Description | Value Range | Default Value |
|---|---|---|---|
| Monitor online status | If checked, you will be notified via System Status or the Mailer if the device is no longer available or goes offline. | - | - |
| Serial number | Specifies the serial number of the device. Enter 'Auto' to automatically pair a Tree device with unknown serial number. This can only be used if there is only one Tree device of the same type on a standalone Miniserver (not in a Client-Gateway setup). Save in the Miniserver to pair the Tree device. Afterwards the program must be loaded from the Miniserver to transfer the actual serial number of the Tree device into the program. | - | - |
| Duration of complete movement [s] | Duration of complete movement in seconds Measured automatically after the first movement (this motor has no speed setting) | 1...600 | 30 |
| Curtain type | How the curtain opens. Determines the animation shown in the app. | - | - |
| Inverted Direction | Invert direction. Required when Up/Down connection is made the wrong way round. | - | - |
Safety Instructions↑
Installation must be carried out by a qualified electrician in accordance with the applicable regulations.
Documents↑
Datasheet Curtain Control Tree for Silent Gliss 5600