LED Spot WW Tree Gen. 1

The LED Spot WW Tree is a recessed LED spot with warm white light for 24VDC supply. The connection to the Miniserver is via Loxone Tree technology.

Datasheet LED Spot WW Tree Gen. 1

Table of Contents


Mounting

Switch off the supply voltage before installation.

Connect the power supply (orange/white wire) and Tree communication wires (green/white wire).

Flip the spring clips back and snap the spotlight into the mounting hole. Make sure that no wires are jammed.


Commissioning

Then follow the pairing procedure on the Tree Interface.


Actuators

Summary Description Value Range
Smart Actuator WW Smart actuator




Diagnostic Inputs

Summary Description Unit Value Range
Online Status LED Spot WW Tree Gen. 1 Indicates whether the device can be reached by the Miniserver.
Diagnostics for Air devices
Diagnostics for Tree devices
Diagnostics for Extensions
Digital 0/1




Properties

Summary Description Default Value
Monitor Online Status When selected, you will be notified via System Status or the Mailer if the device is no longer available or goes offline. -
Serial Number Specifies the serial number of the device.
For Extensions: Enter 'Auto' to automatically pair an extension with unknown serial number.
This can only be used if there is only one Extension of the same type.
Save into the Miniserver, in order to pair the Extension.
Afterwards the program must be loaded from the Miniserver to transfer the actual serial number of the Extension into the program.
-
Device type Tree device type -
Actuator Type Use device with Standard Actuator(s) or Smart Actuator(s)
Smart Actuators support dynamic fade times and can only be used with the Lighting Controller.
-




Safety Instructions

The installation must be carried out by a qualified technician in accordance with all applicable regulations.

Ensure that the device is protected from water.

The device must not be used as part of safety-critical systems.


Documents

Datasheet LED Spot WW Tree Gen. 1