The LED Spot RGBW Tree is a recessed LED spot with warm white and coloured light for supply from 24VDC. The connection to the Miniserver is via Loxone Tree technology.
Table of Contents
Mounting↑
Switch off the supply voltage before installation.
Connect the power supply (orange/white wire) and Tree communication wires (green/white wire).
Flip the spring clips back and snap the spotlight into the mounting hole. Make sure that no wires are jammed.
Commissioning↑
Then follow the pairing procedure
Actuators↑
Summary | Description | Value Range |
---|---|---|
Smart actuator RGBW | Smart actuator | ∞ |
Diagnostic Inputs↑
Summary | Unit | Value Range |
---|---|---|
Online Status LED Spot RGBW Tree | Digital | 0/1 |
Properties↑
Summary | Description | Default Value |
---|---|---|
Monitor Online Status | When selected, you will be notified via System Status or the Mailer if the device is no longer available or goes offline. | - |
Serial Number | Specifies the serial number of the device. For Extensions: 'Auto' may only be used if only one Extension of this type is being used. |
- |
Device type | Tree device type | - |
Actuator Type | Use device with Standard Actuator(s) or Smart Actuator(s) Smart Actuators support dynamic fade times and can only be used with the Lighting Controller. |
- |
Safety Instructions↑
The installation must be carried out by a qualified technician in accordance with all applicable regulations.
Ensure that the device is protected from water.
The device must not be used as part of safety-critical systems.