Nano DI Tree

The Nano DI Tree is a compact module that adds 6 digital inputs via the Loxone Tree technology.

Datasheet Nano DI Tree

Table of Contents


Mounting↑

Install the device in a suitable installation box.

Connect the power supply (orange/white terminal) and Tree communication wires (green/white terminals). Shortly after power-up, the status LED will blink orange if the wiring is correct (connection to Tree Extension and Miniserver is established).


Commissioning↑

Then follow the pairing procedure


Sensors↑

Summary Unit Value Range
Input 1 Digital 0/1
Input 2 Digital 0/1
Input 3 Digital 0/1
Input 4 Digital 0/1
Input 5 Digital 0/1
Input 6 Digital 0/1




Diagnostic Inputs↑

Summary Unit Value Range
Online Status Nano DI Tree Digital 0/1




Properties↑

Summary Description Default Value
Monitor Online Status When selected, you will be notified via System Status or the Mailer if the device is no longer available or goes offline. -
Serial Number Specifies the serial number of the device.
For Extensions: Enter 'Auto' to automatically pair an extension with unknown serial number.
This can only be used if there is only one Extension of the same type.
Save into the Miniserver, in order to pair the Extension.
Afterwards the program must be loaded from the Miniserver to transfer the actual serial number of the Extension into the program.
-
Device type Tree device type -




Safety Instructions↑

The installation must be carried out by a qualified technician in accordance with all applicable regulations.

The installation requires a suitable enclosure to ensure protection against contact, water and dust.

The device must not be used as part of safety-critical systems.


Documents↑

Datasheet Nano DI Tree