The Loxone LED Ceiling Spot WW Tree provides warm white light. It is controlled and dimmed directly via the Tree interface.
Datasheet LED Ceiling Spot WW Tree
Table of Contents
Mounting↑
Switch off the supply voltage before installation.
Mount the base plate to the ceiling. The spot will be held to the base plate by 2 magnets.
Connect the power supply and Tree communication wires.
Then place the lamp on the base plate. Make sure that the magnets are positioned correctly and that no wires are jammed.
The additional safety rope is a security feature and must not be removed!
Commissioning↑
Then follow the pairing procedure
Actuators↑
Summary | Description | Value Range |
---|---|---|
Smart Actuator WW | Smart actuator | ∞ |
Diagnostic Inputs↑
Summary | Unit | Value Range |
---|---|---|
Online Status LED Surface Mount Spot WW Tree | Digital | 0/1 |
Properties↑
Summary | Description | Default Value |
---|---|---|
Monitor Online Status | When selected, you will be notified via System Status or the Mailer if the device is no longer available or goes offline. | - |
Serial Number | Specifies the serial number of the device. For Extensions: 'Auto' may only be used if only one Extension of this type is being used. |
- |
Device type | Tree device type | - |
Actuator Type | Use device with Standard Actuator(s) or Smart Actuator(s) Smart Actuators support dynamic fade times and can only be used with the Lighting Controller. |
- |
Safety Instructions↑
The installation must be carried out by a qualified technician in accordance with all applicable regulations.
Ensure that the device is protected from water.
The device must not be used as part of safety-critical systems.
Documents↑
Datasheet LED Ceiling Spot WW Tree