The Leaf Air is a decentralized ventilation unit with heat recovery that is controlled via Loxone Air technology. Several units are combined, providing room ventilation. More information about the operating method and a configuration tool for the recommended number of units can be found on the website of our cooperation partner: Leaf Ventilation.
Table of Contents
- Mounting
- Commissioning
- Maintenance, filter replacement
- Inputs, Outputs, Properties
- Safety Instructions
- Documents
Mounting↑
Install the device according to the manufacturer's installation and operating instructions.
Commissioning↑
In delivery state, pairing mode will be active after the power supply has been established. This is indicated by the status LED flashing red/green/orange.
Then follow the pairing procedure
To activate the pairing mode manually, switch off the power for 10 seconds, then switch it back on. If no connection to a Miniserver can be established for two minutes, then pairing mode is activated for 30 minutes.
Maintenance, filter replacement↑
The fan filter must be replaced or cleaned at regular intervals based on the maintenance manual. The filter change interval can be defined in the Leaf 1 properties. This setting is 3 months (2200h) by default. The actual run-time of the fan is considered. You will be notified of an upcoming maintenance in the user interface.
Actuators↑
Summary | Unit |
---|---|
API Connector | Text |
Diagnostic Inputs↑
Summary | Unit | Value Range |
---|---|---|
Online Status Leaf Air | Digital | 0/1 |
Filterwarnung | Digital | 0/1 |
Fan error | Digital | 0/1 |
Aperture Error | Digital | 0/1 |
Properties↑
Summary | Description | Value Range | Default Value |
---|---|---|---|
Monitor Online Status | When selected, you will be notified via System Status or the Mailer if the device is no longer available or goes offline. | - | - |
Serial Number | Serial number of the Air device | - | - |
Device type | Air device type | - | - |
Filter Change Interval | After this time (in hours) the filter warning becomes active. | ∞ | - |
Safety Instructions↑
The installation must be carried out by a qualified technician in accordance with all applicable regulations.
The device must not be used as part of safety-critical systems.
Please note the safety instructions in the following installation and operating manual.
Documents↑
Installation and operating instructions with technical data