Husqvarna

The Husqvarna plugin allows the integration of compatible Husqvarna robot lawn mowers. It can be used to initiate a mowing session, park the robot, or display the charge status and current activity. More information about Husqvarna can be found here.

A Husqvarna account is required for use! Please note the Miniserver Gen. 1 is not supported.

Table of Contents


Configuration

Setup

First, Husqvarna must be added. To do so, click on Network Periphery in the periphery tree, then Add Network Device and select Husqvarna.

Authentication

After initially saving to the Miniserver, you must authenticate with your Husqvarna account. Please wait for the system status message asking you to allow your Miniserver access to your Husqvarna devices.

If the Husqvarna status changes to red after saving to the Miniserver, the connection to the Husqvarna server could not be established.

If communication to the Husqvarna server is interrupted for more than 10 days, the authentication process must be repeated.

Add Devices

If the authentication was successful, your Husqvarna devices can be added via Device Search in Loxone Config.


Notes for Use

Mowing and Parking

Each robot lawnmower has an output for starting the mowing process and one for parking the unit. A command is triggered by a rising edge on the corresponding output.

A rising edge on the Park actuator, parks the robot until a new command is sent to the unit.

Both commands will override the actions from the Calendar in the Husqvarna App.

Status Information

Due to request limitations of the Husqvarna service, the status information of the devices can only be requested once every 10 minutes. In addition, the data is always updated immediately after a command is sent. For more information see Too many requests.


Too many requests

For requests on the Husqvarna service, the following limits per account apply:

  • Max. 1 request per second. Any additional requests will be throttled.

  • Max. 10000 requests per month. Any additional requests will be throttled.

Requesting status information every 10 minutes uses about half of the maximum available requests per month.

Avoid configuration that changes actuator state frequently.

Diagnostic Inputs

Summary Unit Value Range
Online Status Husqvarna Digital 0/1




Properties

Summary Description Default Value
Monitor service If checked, you will be notified by the System Status or Cloud Mailer if this service is no longer available or offline. -