The Loxone Door & Window Contact Air is a wireless sensor with reed contact that responds to a magnet and enables the monitoring of doors and windows, whether they are open or closed.
Table of Contents
- Battery Replacement
- Inputs, Outputs, Properties
- Safety Instructions
Place the self-adhesive magnet so that the contact activates when the window is closed. The magnet must be placed close to the green notch on the side.
|When mounted to metallic surfaces, the range may be significantly reduced.|
In delivery state, pairing mode will be active after inserting the battery. This is indicated by the status LED flashing red/green/orange.
To activate the pairing mode manually, hold down the pairing button for at least 5 seconds after inserting the battery. The pairing button is located on the top of the device:
Use the white button as a slider to eject the battery to the side. Then insert a new CR2032 lithium battery. Make sure that the battery is completely inserted into the device and that the button can be operated correctly.
|Input 1||To use the pairing button as Input|
|Contact||Input is active when magnet is detected (e.g. door closed)|
|Online Status Door and Window Contact Air||Digital||-|
|Battery Low||This sensor switches on when the batteries are at a low state of charge.||Digital||-|
|Battery Level||This sensor indicates the current battery level.||%||∞|
|Monitor online status||You will be notified via System Status or Could Mailer if the device is no longer available or offline.
As this device and it's functionality are critical to safety, it is not possible to disable this setting for this device.
|Air serial number||Serial number of the Air device||-|
|Device type||Air device type||-|
Ensure that the device is protected from water.
The device must not be used as part of safety-critical systems.