SETTING UP YOUR LOXONE EXTENSION

Installation

  1. Mount the Extension on the DIN rail
  2. Connect 24V DC power supply, but do not switch on until the whole installation is completed (We recommend looping through the Miniserver)
  3. Connect the inputs and outputs
  4. Connect the Loxone bus
  5. Note: If it's the last extension, terminate the Loxone Bus with a 120Ω resistor (included with the Miniserver)
  6. Turn on the power supply
  7. After a few seconds, the left LED will flash green if the extension is already configured, or orange if not

Quick Connection Guide

Software Download Download installation and quick connection guide (pdf)

Configuring the Extension

Insert Extension

Insert Extension

In the configuration software, connect to your Miniserver and download the existing configuration (if there is one) from the Miniserver.

Select the "Devices" drop-down menu on the "Periphery" tab and select "Extension". All the Extension's inputs and outputs are available for you to use in the periphery.
Inbetriebnahme-SN-Erweiterung

Enter serial number

Click on the Extension in the periphery tree. Enter the serial number of your Extension in the properties section.

info2 Serial number
The serial number is on the back of your Extension. You can find the number just below the barcode (see picture).
 Save in Miniserver

Save configuration in the Miniserver

After entering your extension's serial number, click on the "Miniserver" tab and select "Save in Miniserver". The controller reboots and after about 7 seconds, both status LEDs on the extension will turn green.