Bekabeling Miniserver & Extensions

A guide to wiring your house for our home automation solution.

CONNECTING THE MINISERVER TO A POWER SUPPLY

  1. Connect the DC output of the 24V power supply to the power terminals on the Miniserver.
  2. Connect the 24V power supply to the mains only once you have finished the rest of the installation.

Whenever work is done on the cabling of the Miniserver please ensure that power to the Miniserver is removed. Damaged components can occur if this is not observed.

bekabeling miniserver

CONNECTING THE MINISERVER TO SEVERAL POWER SUPPLIES

Wiring example for connecting the Miniserver to several power supplies.

You must connect all the power supply GND’s together. Otherwise problems may occur due to difference in potential.

miniserver meerdere voedingen aansluiten

CONNECTING ONE OR MORE EXTENSIONS TO THE MINISERVER

  1. Connect the power terminals of the Miniserver to the power terminals on the Extensions.
  2. Connect the Loxone Link connector of the Miniserver with the Loxone Link connector of the Extension.
  3. Terminate the Loxone Link at the last Extension with a 120 Ohm resistor (comes with your Miniserver package).

Note: If no Extension is connected there is no need to use a 120 Ohm resistor.

extension met de miniserver verbinden loxone

CONNECTING ONE OR MORE EXTENSIONS TO THE MINISERVER GO

  1. Connect the Ground terminal of the Miniserver Go to the power terminals on the Extensions.
  2. Connect the Loxone Link connector of the Miniserver Go with the Loxone Link connector of the Extension.
  3. Terminate the Loxone Link at the last Extension with a 120 Ohm resistor (comes with your Miniserver package).

Note: If no Extension is connected there is no need to use a 120 Ohm resistor.

extensions met miniserver go verbinden

The power should be removed whenever working on the installation, but that if this is not possible then ensure that the blue Link connector is always unplugged before the power connector to prevent damage to the communication circuitry.

Lees hier verder over de bekabeling van sensoren en actuatoren