Loxone Support Community

Find answers, ask questions and become part of the Loxone Community.

Loxone Support Community › Category: Loxone Config › Nightlight touch air conditional temperature?
0 Vote Up Vote Down
2 years ago
Nightlight touch air conditional temperature?

I’ve recently had installed a nightlight touch air for a bedside table, and am wondering if it’s possible to better control when the temperature is displayed? Currently it seems that if the Loxone Config has the temperature output present at all, the nightlight will flip between current time and temperature every 5 seconds. In the dark room, at minimum brightness, this is quite noticeable.

Is it at all possible to configure this 5 second flip to occur only a certain times or in certain operating modes (e.g. do not show temperature when Night mode is active?)

2 Answers
0 Vote Up Vote Down
2 years ago

Hi Sean

I’m afraid that this is not a definable parameter and is always a fixed time between the change from time to temperature.

The only suggestion I could make would be to define in logic that at night time the display brightness is ‘0’ and therefore the display wouldn’t be visible at all.

KR

Hugh

0 Vote Up Vote Down
2 years ago

Thanks Hugh,

I feared this would be the case – brightness 0 unfortunately means you can’t see the time either – which I would like to see!

Perhaps this is possible in some future version of the software and not a hardware limitation?

Best regards

Sean